To Next Page

To Previous Page

IPv6 Addressing Configuration

View the Current IPv6 Addressing Configuration

ProCurve(config)# show ipv6 vlan 10

Internet (IPv6) Service

IPv6 Routing : Disabled

Default Gateway : 10.0.9.80

ND DAD : Enabled

DAD Attempts : 3

Vlan Name : VLAN10

IPv6 Status : Enabled

IPv6 Address/Prefixlength Expiry

------------------------------------------- -------------------------

2620:0:a03:e102::127/64 Wed Jan 23 14:16:17 2008

2620:0:a03:e102:212:79ff:fe88:a100/64 Sat Jan 5 05:02:22 2008

fe80::127/64 permanent

Figure 4-2. Example of Show IPv6 VLAN < vid > Output

Syntax: show run

In addition to the other elements of the current configuration,

this command lists the statically configured, global unicast

and anycast IPv6 addressing, and the current IPv6 configura-

tion per-VLAN. The listing may include one or more of the

following, depending on what other IPv6 options are config-

ured on the VLAN. Any stateless address autoconfiguration

(SLAAC) commands in the configuration are also listed in the

output, but the actual addresses resulting from these

commands are not included in the output.

■ ipv6 enable

■ ipv6 address fe80::< device-id > link-local

■ ipv6 address < prefix >:< device-id >/< prefix-length >

■ ipv6 address autoconfig

■ ipv6 address dhcp full [rapid-commit]

■ ipv6 < global-unicast-address >/< prefix > anycast

4-25

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General