HP PROCURVE 2910AL Configuration Guide

IPv6 Addressing Configuration
View the Current IPv6 Addressing Configuration
ProCurve(config)# show run
Running configuration:
.
.
.
vlan 10
name "VLAN10"
untagged A1-A12
ipv6 address fe80::127 link-local
Statically configured IPv6 addresses
appear in the show run output.
ipv6 address 2001:db8::127/64
ipv6 address 2001:db8::15:101/64 anycast
ipv6 address autoconfig
.
.
.
Commands for automatic IPv6 address
configuration appear in the show run
output, but the addresses resulting from
these commands do not appear in the
output.
Figure 4-3. Example of Show Run Output Listing the Current IPv6 Addressing Commands
4-26

HP PROCURVE 2910AL Specifications

General

Model	HP ProCurve 2910al
Switching Capacity	128 Gbps
Throughput	95.2 Mpps
Management	Web, CLI, SNMP
Jumbo Frame Support	Yes
Manageable	Yes
Power	100-240 VAC
Power Supply	Internal
Operating Temperature	0°C to 45°C (32°F to 113°F)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF
Features	IPv6, VLAN, QoS, ACLs
Operating Humidity	15% to 95% non-condensing
Uplink Ports	4
Power over Ethernet	Yes (PoE+ models available)