HP ProCurve 5406zl Access Security Guide

TACACS+ Authentication
Messages Related to TACACS+ Operation
Messages Related to TACACS+
Operation
The switch generates the CLI messages listed below. However, you may see
other messages generated in your TACACS+ server application. For informa-
tion on such messages, refer to the documentation you received with the
application.
CLI Message Meaning
Connecting to Tacacs server- The switch is attempting to contact the TACACS+ server identified in the switch’s tacacs-
server
configuration as the first-choice (or only) TACACS+ server.
Connecting to secondary The switch was not able to contact the first-choice TACACS+ server, and is now
Tacacs server- attempting to contact the next (secondary) TACACS+ server identified in the switch’s
tacacs-server configuration.
Invalid password- The system does not recognize the username or the password or both. Depending on the
authentication method (tacacs or local), either the TACACS+ server application did not
recognize the username/password pair or the username/password pair did not match the
username/password pair configured in the switch.
No Tacacs servers
responding
The switch has not been able to contact any designated TACACS+ servers. If this message
is followed by the Username prompt, the switch is attempting local authentication.
Not legal combination of
authentication methods
For console access, if you select tacacs as the primary authentication method, you must
select local as the secondary authentication method. This prevents you from being locked
out of the switch if all designated TACACS+ servers are inaccessible to the switch.
Record already exists- When resulting from a
tacacs-server host <ip addr> command, indicates an attempt to
enter a duplicate TACACS+ server IP address.
Operating Notes
■ If you configure Authorized IP Managers on the switch, it is not
necessary to include any devices used as TACACS+ servers in the
authorized manager list. That is, authentication traffic between a
TACACS+ server and the switch is not subject to Authorized IP
Manager controls configured on the switch. Also, the switch does not
attempt TACACS+ authentication for a management station that the
Authorized IP Manager list excludes because, independent of
TACACS+, the switch already denies access to such stations.
5-25

HP ProCurve 5406zl Specifications

General

Product Name	HP ProCurve 5406zl
Category	Switch
Layer	Layer 3
Operating Temperature	32°F to 131°F (0°C to 55°C)
Operating Humidity	15% to 95% non-condensing
Management	SNMP, CLI
Power Supply	Redundant power supplies (optional)
Memory	128 MB flash, 512 MB SDRAM