HP ProCurve 5406zl Access Security Guide

Configuring Port-Based and Client-Based Access Control (802.1X)
Option For Authenticator Ports: Configure Port-Security To Allow Only 802.1X-Authenticated Devices
Port-Security
Note If 802.1X port-access is configured on a given port, then port-security learn-
mode for that port must be set to either continuous (the default) or port-access.
In addition to the above, to use port-security on an authenticator port (chapter
11), use the per-port client-limit option to control how many MAC addresses
of 802.1X-authenticated devices the port is allowed to learn. (Using client-limit
sets 802.1X to client-based operation on the specified ports.) When this limit
is reached, no further devices can be authenticated until a currently authen-
ticated device disconnects and the current delay period or logoff period has
expired.
Configure the port access type.
Syntax: aaa port-access auth < port-list > client-limit < 1 - 32 >
Configures client-based 802.1X authentication on the
specified ports and sets the number of authenticated
devices the port is allowed to learn. For more on this
command, refer to
“Configuring Switch Ports as 802.1X
Authenticators” on page 10-16.)
— Or —
no aaa port-access auth < port-list > client-limit
Configures port-based 802.1X authentication on the
specified ports, which opens the port. (Refer to “User
Authentication Methods” on page 10-4.)
10-41

HP ProCurve 5406zl Specifications

General

Product Name	HP ProCurve 5406zl
Category	Switch
Layer	Layer 3
Operating Temperature	32°F to 131°F (0°C to 55°C)
Operating Humidity	15% to 95% non-condensing
Management	SNMP, CLI
Power Supply	Redundant power supplies (optional)
Memory	128 MB flash, 512 MB SDRAM