Virus Throttling
Operating Notes
Operating Notes
■ Ace Types: A connection-rate ACL allows you to configure two types
of ACEs (Access Control Entries):
• ignore < source-criteria >: This ACE type directs the switch to permit
all inbound traffic meeting the configured < source-criteria > without
filtering the traffic through the connection-rate policy configured on
the port through which the traffic entered the switch. For example,
ignore host 15.45.120.70 tells the switch to permit traffic from the host
at 15.45.120.70 without filtering this host’s traffic through the connec-
tion-rate policy configured for the port on which the traffic entered
the switch.
• filter < source-criteria >: This ACE type does the opposite of an ignore
entry. That is, all inbound traffic meeting the configured < source-
criteria > must be filtered through the connection-rate policy config-
ured for the port on which the traffic entered the switch. This option
is most useful in applications where it is easier to use filter to specify
suspicious traffic sources for screening than to use ignore to specify
exceptions for trusted traffic sources that don’t need screening. For
example, if the host at 15.45.127.43 requires connection-rate screen-
ing, but all other hosts in the VLAN do not, you would configure and
apply a connection-rate ACL with filter ip host 15.45.127.43 as the first
ACE and ignore ip any as the second ACE. In this case, the traffic from
host 15.45.127.43 would be screened, but traffic from all other hosts
on the VLAN would be permitted without connection-rate screening.
■ Implicit ACE: A connection-rate ACL includes a third, implicit filter
ip any ACE which is automatically the last ACE in the ACL. This
implicit ACE does not appear in displays of the ACL configuration,
but is always present in any connection-rate ACL you configure. For
example, assume that a port is configured with a connection-rate
policy and is in a VLAN configured with a connection-rate ACL. If
there is no match between an incoming packet and the ACE criteria
in the ACL, then the implicit filter ip any sends the packet for screening
by the connection-rate policy configured on that port. To preempt the
implicit filter ip any in a given connection-rate ACL, you can configure
ignore IP any as the last explicit ACE in the connection-rate ACL. The
switch will then ignore (permit) traffic that is not explicitly addressed
by other ACEs configured sequentially earlier in the ACL without
filtering the traffic through the existing connection-rate policy.
3-30
To Next Page
Loading...
Need help?
General
