Configuring Port-Based and Client-Based Access Control (802.1X)
Displaying 802.1X Configuration, Statistics, and Counters
Displaying 802.1X Configuration,
Statistics, and Counters
802.1X Authentication Commands
802.1X Supplicant Commands
802.1X Open VLAN Mode Commands
802.1X-Related Show Commands
show port-access authenticator
show port-access supplicant
Details of 802.1X Mode Status Listings
RADIUS server configuration
page 10-16
page 10-42
page 10-24
below
page 10-52
page 10-48
pages 10-22
Show Commands for Port-Access Authenticator
Syntax: show port-access authenticator [< port-list >]
[config | statistics | session-counters | vlan]
•Without [< port-list > [config | statistics | session-counters
| vlan]], displays whether port-access authenticator is
active (Yes or No) and the status of all ports
configured for 802.1X authentication. Includes the
the port traffic priority (CoS) assigned to inbound
traffic and the rate-limit settings, if any, specified by
a RADIUS server for a current 802.1X authenticated
client session. (Refer to
“RADIUS-Administered CoS
and Rate-Limiting” on page 6-4 in this guide.)
•With < port-list > only, same as above, but only for the
specified port. Does not display data for a specified
port that is not enabled as an authenticator.
•With [< port-list > [config | statistics | session-counters |
vlan]], displays the [config | statistics | session-counters]
data for the specified port(s). Does not display data
for a specified port that is not enabled as an
authenticator.
•With [config | statistics | session-counters | vlan] only,
displays the [config | statistics | session-counters] data
for all ports enabled as authenticators.
For more on the [config | statistics | session-counters | vlan]
options refer to the next section of this table.
10-46
To Next Page
Loading...
Need help?
General
