HP ProCurve 5406zl Access Security Guide

Configuring Port-Based and Client-Based Access Control (802.1X)
802.1X Open VLAN Mode
Table 10-2. 802.1X Open VLAN Mode Options
802.1X Per-Port Configuration Port Response
No Open VLAN mode: The port automatically blocks a client that cannot initiate an
authentication session.
Open VLAN mode with both of the following configured:
Unauthorized-Client VLAN •
•
•
When the port detects a client without 802.1X supplicant
capability, it automatically becomes an untagged member of this
VLAN. If you previously configured the port as a static, tagged
member of the VLAN, membership temporarily changes to
untagged while the client remains unauthenticated.
If the port already has a statically configured, untagged
membership in another VLAN, then the port temporarily closes
access to this other VLAN while in the Unauthorized-Client VLAN.
To limit security risks, the network services and access available
on the Unauthorized-Client VLAN should include only what a client
needs to enable an authentication session. If the port is statically
configured as a tagged member of any other VLANs, access to
these VLANs is blocked while the port is a member of the
Unauthorized-Client VLAN.
Note for a Port Configured To Allow Multiple Client Sessions: If any
previously authenticated clients are using a port assigned to a VLAN
other than the Unauthorized-Client VLAN, then a later client that is
not running 802.1X supplicant software is blocked on the port until all
other, authenticated clients on the port have disconnected.
10-27

HP ProCurve 5406zl Specifications

General

Product Name	HP ProCurve 5406zl
Category	Switch
Layer	Layer 3
Operating Temperature	32°F to 131°F (0°C to 55°C)
Operating Humidity	15% to 95% non-condensing
Management	SNMP, CLI
Power Supply	Redundant power supplies (optional)
Memory	128 MB flash, 512 MB SDRAM