A-9
File Transfers
Transferring Switch Configurations
File Transfers
2. At the command prompt, execute the following commands:
To upload a configuration to a file on a PC or Unix workstation:
put
IP_address
CONFIG
remote_file
To download a configuration from a file on a PC or Unix workstation:
get
IP_address
CONFIG
remote_file
where:
IP address
is the address of the PC or Unix
workstation in which the configuration is to be stored.
remote_file
is the name of the configuration file in the PC or
Unix workstation
Sraswb.book : SIER_SWA.FM Page 9 Tuesday, June 30, 1998 12:20 PM
To Next Page
Loading...
