6-6
Configuring the Switch
IP Configuration
Configuring the Switch
Configuring IP Address from the Web Browser Interface
Figure 6-2. Configuring IP Addressing on the Web Browser Interface
5.Click on this to activate
the changes you made in
steps 3 and 4.
4. Enter an IP address, subnet
mask, and, if needed, the IP
address of the default gateway.
1. Click here.
2. Click here.
3.To enable manual entry
of the IP address, set this
to “Manual”.
Sraswb.book : SIER_SW6.FM Page 6 Tuesday, June 30, 1998 12:20 PM
To Next Page
Loading...
