7-12
Monitoring and Analyzing Switch Operation
Port Address Table
Monitoring and Analyzing
Switch Operation
Port Address Table
This screen lets you determine which devices are attached to the selected
switch port by listing all of the MAC addresses detected on that port.
To access the port address table:
1. From the Main Menu click on:
1. Status and Counters
6. Port Address Table
Figure 7-10. Example of How To Access the Port Address Table
2. When the prompt appears, press the Space bar or type the port number
to display the port you want to examine, then press [Enter]. (See figure 7-10,
above.)
You will then see a list of the MAC addresses that have been detected on
the selected port, as shown in figure 7-11 on the next page. Each port is
identified by the sequential port numbers on the front of the switch.
2. Type in the number of the port for which
you want to display the address table.
1. Select this parameter.
Sraswb.book : SIER_SW7.FM Page 12 Tuesday, June 30, 1998 12:20 PM
To Next Page
Loading...
Need help?
General