Removal and replacement procedures 47
To install a non-hot-plug hard drive:
1. Put the non-hot-plug hard drive disk into the carrier.
2. Fasten the HDD to the carrier using the screws (two on each side).
Figure 20 Installing the Non-hot-plug Hard Drive Disk into the Carrier
To install a non-hot-plug hard drive into the server:
1. Remove the hard drive blank from the front of the system if installed.
2. Push the hard drive assembly into the drive bay until it stops.
Figure 21 Installing the Non-hot-plug Hard Drive Assembly
3. Fasten the screw with the T-10/T-15 wrench provided to secure the hard drive to the chassis.
To Next Page
Loading...
