Removal and replacement procedures 86
Power supply unit (PSU)
Located on the rear panel of the server power supply is a standard autoranging 750 W or 500 W
non-hot-plug PSU.
Figure 78
Hot-plug Power Supply Unit
To remove the hot-plug power supply:
1. Press the purple tab.
2. Pull the hot-plug power supply out of the power supply bay
Figure 79
Removing the Hot-plug Power Supply
To reinstall the hot-plug power supply:
1. Align the hot-plug power supply cage connector with the open power supply bay and slide the
power supply into the chassis.
2. Push it in until the locking tab is clicked.
To Next Page
Loading...
