To replace the component, reverse the removal procedure.
Removing and replacing a power supply blank
To replace the component, reverse the removal procedure.
Removing and replacing the AC power supply
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all bays are
populated with either a component or a blank.
Procedure
1. Power down the server (Powering down the server on page 33).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Access the product rear panel ( Releasing the cable management arm on page 34).
4. Remove the power supply.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the power supply or power supply blank
to cool before touching it.
Removing and replacing a power supply blank 39
To Next Page
Loading...
