HP ProLiant DL360 Gen10 - Removing and Replacing a Primary Riser Card

To replace the component, reverse the removal procedure.
Removing and replacing a primary riser card
CAUTION:
To prevent damage to the server or expansion boards, power down the server and remove all AC power
cords before removing or installing the PCI riser cage.
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack.
b. Remove the server from the rack.
4. Remove the access panel.
5. Remove the riser cage.
46 Removing and replacing a primary riser card