a. Extend the server from the rack.
b. Remove the server from the rack.
4. Remove the access panel.
5. Remove all riser cages.
6. Remove the switch and then disconnect the cable.
Removing and replacing the intrusion detection switch
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack.
b. Remove the server from the rack.
4. Remove the access panel.
5. Disconnect the cable and remove the switch.
Removing and replacing the intrusion detection switch 49
To Next Page
Loading...
