HP ProLiant DL380 - System Cannot Load Smartstart; Smartstart Fails During Installation

138 HP ProLiant DL380 Generation 3 Server User Guide
System Cannot Load SmartStart
Possible Cause Possible Solution
A SmartStart requirement is
not met.
Check the SmartStart Release Notes provided
in the SmartStart Online Reference
Information on the SmartStart CD.
A CD-ROM drive cable is not
connected to CD-ROM drive.
Be sure the CD-ROM drive cables are
properly connected.
Existing software is causing
conflict.
Clear NVRAM and boot drives in RBSU and
reinstall the operating system.
IMPORTANT: Clearing NVRAM removes user data from the boot drives. To
clear NVRAM and erase the boot drives, select the Advanced Options menu
in RBSU, and then select Erase NVRAM/Boot Space Disk.
SmartStart Fails During Installation
Possible Cause Possible Solution
An error occurs during
installation.
Follow the error information provided. If
necessary, clear NVRAM in RBSU and
reinstall the operating system.
The CMOS is not cleared. Clear NVRAM in RBSU and reinstall the
operating system.
IMPORTANT: Clearing NVRAM removes user data from the boot drives. To
clear NVRAM and erase the boot drives, select the Advanced Options menu
in RBSU, and then select Erase NVRAM/Boot Space Disk.
HP CONFIDENTIAL
File Name: 303130-3.doc Last Saved On: 7/7/03 1:48 PM