HP ProLiant DL380 - Hardware Options Installation; Processor and Memory Installation

65
Hardware Options Installation
In This Section
Introduction ............................................................................................................................65
Processor Option ....................................................................................................................65
Memory Options.....................................................................................................................69
Hot-Plug SCSI Hard Drive Options ....................................................................................... 72
Hot-Plug Tape Drive Option .................................................................................................. 75
Battery-Backed Write Cache Enabler Option.........................................................................77
Redundant Hot-Plug Fans.......................................................................................................79
Redundant Hot-Plug AC Power Supply Option .....................................................................84
DC Power Supply Option....................................................................................................... 87
Expansion Board Options....................................................................................................... 91
Introduction
If more than one option is being installed, read the installation instructions for all
of the hardware options and identify similar steps to streamline the installation
process.
WARNING: To reduce the risk of personal injury from hot
surfaces, allow the drives and the internal system components to
cool before touching them.
CAUTION: To prevent damage to electric components,
properly ground the server before beginning any installation procedure.
Improper grounding can cause electrostatic discharge.
Processor Option
The server supports single- and dual-processor operation. With two processors
installed, the server supports boot functions through the processor installed in
processor socket 1. However, if processor 1 fails, the system automatically boots
from processor 2 and provides a processor failure message.
HP CONFIDENTIAL
File Name: 303130-3.doc Last Saved On: 7/7/03 1:48 PM