18 HP ProLiant DL385 Server Maintenance and Service Guide
4. Press the Power On/Standby button to place the server in standby mode (2).
When the server activates standby power mode, the system power LED
changes to amber.
5. If the server is installed in a rack, locate the server by identifying the
illuminated rear UID LED button.
6. Disconnect the power cords.
The system is now without power.
Removing the server from the rack
To remove the server from an HP, Compaq branded, telco, or third-party rack:
1. Power down the server ("Powering down the server" on page 17
).
2. Extend the server from the rack ("Extending the Server from the Rack" on
page 16
).
3. Disconnect the cabling and remove the server from the rack. For more
information, refer to the documentation that ships with the rack mounting
option.
4. Place the server on a sturdy, level surface.
To Next Page
Loading...
