HP ProLiant DL385 - Power Button;LED Board; DIMMs

Removal and replacement procedures 41
Power Button/LED Board
To remove the component:
1. Power down the server ("Powering down the server" on page 17
).
2. Extend or remove the server from the rack ("Extending the Server from the
Rack" on page 16
, "Removing the server from the rack" on page 18).
3. Remove the front bezel ("Front Bezel" on page 24
).
4. Remove the access panel ("Removing the access panel" on page 19
).
5. Remove the BBWC battery pack. ("Battery-Backed Write Cache Battery
Pack" on page 30
)
6. Remove the power button/LED board.
To replace the component, reverse the removal procedure.
DIMMs
To remove the component:
1. Power down the server ("Powering down the server" on page 17).
2. Extend or remove the server from the rack ("Extending the Server from the
Rack" on page 16
, "Removing the server from the rack" on page 18).