Removal and replacement procedures 67
5. Remove the SCSI terminator board.
Installing the SCSI terminator board
1. Power down the server ("Powering down the server" on page 17
).
2. Extend or remove the server from the rack ("Extending the Server from the
Rack" on page 16
, "Removing the server from the rack" on page 18).
3. Remove the access panel ("Removing the access panel" on page 19
).
4. Remove the front fan bracket ("Front fan bracket" on page 25
).
IMPORTANT: For this procedure, you do not need to remove the hot-
plug fans from the front fan bracket. When reinstalling the front fan
bracket, press the top of each fan to be sure it seats securely.
NOTE: For more information on preparing the server for installation or
removal procedures, refer to the Documentation CD.
To Next Page
Loading...
