Removal and replacement procedures 19
Removing the access panel
WARNING: To reduce the risk of personal injury from hot
surfaces, allow the drives and the internal system components to
cool before touching them.
CAUTION: Do not operate the server for long periods without
the access panel. Operating the server without the access panel results
in improper airflow and improper cooling that can lead to thermal
damage.
1. Power down the server if performing a non-hot-plug installation or
maintenance procedure ("Powering down the server" on page 17
).
2. Extend the server from the rack, if applicable ("Extending the Server from
the Rack" on page 16
).
3. Lift up on the hood latch handle and remove the access panel.
Opening the Cable Management Arm
To access the server rear panel, open the cable management arm:
To Next Page
Loading...
