HP ProLiant DL385 - Non-hot-plug procedures; DVD;CD-ROM Drive

21
Non-hot-plug procedures
In This Section
DVD/CD-ROM Drive ..................................................................................................................21
DVD/CD-ROM Drive Ejector Assembly.....................................................................................22
Diskette Drive Option...................................................................................................................24
Front Bezel ...................................................................................................................................24
Front fan bracket...........................................................................................................................25
Rear fan bracket............................................................................................................................26
Battery-Backed Write Cache Procedures .....................................................................................27
PCI Riser Cage Door Latch..........................................................................................................32
PCI Riser Cage .............................................................................................................................33
Expansion Board ..........................................................................................................................34
Expansion Slot Cover...................................................................................................................36
PCI Slot Release Lever.................................................................................................................37
PCI Lightpipe and Cover..............................................................................................................38
Power converter module...............................................................................................................39
Power Button/LED Board ............................................................................................................41
DIMMs .........................................................................................................................................41
Processor.......................................................................................................................................42
PPM ..............................................................................................................................................45
Battery ..........................................................................................................................................46
System board ................................................................................................................................47
Re-entering the server serial number and product ID...................................................................49
DVD/CD-ROM Drive
To remove the component:
CAUTION: To prevent improper cooling and thermal damage,
do not operate the server unless all bays are populated with either a
component or a blank.
1. Power down the server ("Powering down the server" on page 17).
IMPORTANT: The ejector button is recessed to prevent accidental
ejection; it may be helpful to use a pen or similar shaped object to
access the button.