EasyManua.ls Logo

HP ProLiant DL388 - Unsupported Processor Stepping with AMD Processors

HP ProLiant DL388
194 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Software tools and solutions 86
Updating system ROM without removing the processor
If the "Unsupported Processor Detected" message is displayed, and you choose to leave the processor
installed, the system will only boot the following devices:
Systems ROMPaq Diskette installed in a legacy diskette drive
Systems ROMPaq Diskette installed in a USB diskette drive
Systems ROMPaq USB Key in diskette format
A systems ROMPaq USB key in diskette format is a USB drive key formatted as a diskette drive with the
ROMPaq utility. For information on how to create a systems ROMPaq USB key in diskette format, see
"System ROMPaq Firmware Upgrade Utility (on page 84)."
Updating system ROM after removing the processor
If the "Unsupported Processor Detected" message is displayed, and you choose to remove the processor,
update the system ROM using any standard ROM flash mechanism. After updating the system ROM, install
the new stepping processor.
Unsupported processor stepping with AMD processors
For systems based on AMD processors, you may need to update the system ROM to support new steppings
(revisions) of processors. However, in most cases, a system ROM update is not required.
If the system ROM does not support the new stepping processor, the system does not display any message.
For system ROM update requirements, see the documentation that ships with the processor.

Table of Contents

Other manuals for HP ProLiant DL388

Related product manuals