Removing and replacing a 4-port NVMe mezzanine card
Procedure
1. Power down the server (Power down the server on page 33).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack (Extend the server from the rack on page 33).
• Remove the server from the rack (Removing the server from the rack on page 34).
4. Remove the access panel (Removing the access panel on page 35).
5. Disconnect all cables connected to the mezzanine card.
6. Remove the mezzanine card.
Removing and replacing a 4-port NVMe mezzanine card 49
To Next Page
Loading...
