• Extend the server from the rack (Extend the server from the rack on page 33).
• Remove the server from the rack (Removing the server from the rack on page 34).
4. Remove the access panel (Removing the access panel on page 35).
5. Disconnect all cables attached to the expansion boards in the PCIe riser cage.
6. Remove the PCIe riser cage (Removing and replacing a PCIe riser cage on page 51).
7. Remove the expansion board.
Removing and replacing the HPE 12G SAS Expander Card
Procedure
1. Power down the server (Power down the server on page 33).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack (Extend the server from the rack on page 33).
• Remove the server from the rack (Removing the server from the rack on page 34).
4. Remove the access panel (Removing the access panel on page 35).
5. If installed, do the following:
a. Remove the air baffle (Removing and replacing the air baffle on page 39).
b. Remove the processor mezzanine tray (Removing and replacing the processor mezzanine tray on
page 43).
c. Remove the 2P pass-through performance board (Removing and replacing the 2P pass-through
performance board on page 48).
6. Remove the fan cage (Removing and replacing the fan cage on page 40).
54 Removing and replacing the HPE 12G SAS Expander Card
To Next Page
Loading...
