Removal and replacement procedures 35
1.
Prepare the drive.
2. Install the drive.
3. Determine the status of the drive from the drive LED definitions ("Hot-plug drive LED definitions" on page
83).
Left bezel (USB/video)
To remove the component:
1. Power down the server (on page 25).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend the server from the rack (on page 25).
4. Remove the processor memory drawer cover (on page 31).
To Next Page
Loading...
