Removal and replacement procedures 52
3.
Install the memory cartridge.
4. Install the processor memory drawer cover.
5. Install the processor memory drawer.
6. Power up the server.
Heatsink
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
CAUTION: The heatsink thermal interface media is not reusable and must be replaced if the
heatsink is removed from the processor after it has been installed.
To remove the component:
1. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
2. Remove the processor memory drawer shipping screws. ("Processor memory drawer shipping screw
locations" on page 30)
3. Remove the processor memory drawer (on page 30).
4. Remove the processor memory drawer cover (on page 31).
To Next Page
Loading...
