Removal and replacement procedures 46
CAUTION: In systems that use external data storage, be sure that the server is the first unit to
powered down and the last to be powered back up. Taking this precaution ensures that the system
does not erroneously mark the drives as failed when the server is powered up.
5. Extend the server from the rack (on page 25).
6. Remove the access panel (on page 29).
7. Extend the processor memory drawer approximately 2.54-5.1 cm (1-2 inches).
8. Remove the SPI board (on page 31).
9. Disconnect the capacitor pack cable from the cache module on the SPI board or the PCIe controller.
To Next Page
Loading...
