To cancel the load process, click Cancel.
Firmware Update
HPE ProLiant Gen8 servers and their installed hardware options are pre-loaded with the latest firmware,
but updated firmware might be available. Use the Firmware Update utility to find and apply the latest
firmware for your HPE ProLiant server and installed options. Intelligent Provisioning updates can be
performed when an SPP update is available.
Determining the installed Intelligent Provisioning version
To check the Intelligent Provisioning version, click the System Information
Intelligent Provisioning
Image version is listed.
Updating Intelligent Provisioning and component firmware
NOTE:
Firmware Update reflects the latest updates available as per the baseline defined in the latest SPP.
Newer updates that were added outside of the latest SPP baseline do not appear on the updates
list.
To update Intelligent Provisioning and component firmware:
Procedure
1. Select Firmware Update in the Perform Maintenance window.
2. Immediately after selecting this option, the system searches for firmware on the source configured in
the System Software Update settings (Intelligent Provisioning Preferences on page 32). This
might take a few minutes; wait for the display to generate the results.
3. While the system is retrieving the data, click More or Less to show or hide search details.
4. If preferred, download and copy the SPP ISO to a DVD or USB key. To download SPP, see the HPE
website at http://www.hpe.com/servers/spp/download. For instructions on using the ISO, see the
HPE Service Pack for ProLiant Quick Start Guide on the HPE website (http://www.hpe.com/support/
SPP_UG_en).
5. After the system retrieves the firmware data, it checks the installed hardware components to suggest
items to update. Depending on the search, you might be prompted to click Continue to begin the
hardware components check. This might take a few minutes; wait for the display to generate the
results.
NOTE:
If the Installed Version (displayed on the left side of the window) is newer than the version listed
on the right side of the window, do not select the check box and install that component.
6. Select the items to update, and then click Install. The table is redisplayed, with only the selected items
listed.
7. To install all of the listed components, click Continue. If you are ready to perform the installation, click
Continue at the warning.
After each component is installed, a green check automatically appears in the left column next to the
component name.
Firmware Update 31
To Next Page
Loading...
