Intelligent Provisioning Quick Configs settings and corresponding RBSU settings
Available for HPE ProLiant Gen8 servers, Intelligent Provisioning Quick Configs options provide the
capability to select a basic policy for performance versus power usage, without having to configure
individual settings through RBSU menus.
The following tables show the three Intelligent Provisioning Quick Configs profiles and their corresponding
RBSU option settings.
NOTE:
Not all of the options in this table are adjustable on all servers. However, even if you do not have the
option of adjusting some of these settings, they will default to the values shown here.
Table 1: RBSU settings on Gen8 servers with AMD processors
Intelligent Provisioning Quick Configs settings
RBSU power
management options
Balanced power and
performance
Minimum power usage Maximum performance
HPE Power Profile
Balanced Power and
Performance
Minimum Power Usage Maximum Performance
HPE Power Regulator
HPE Dynamic Power
Savings Mode
HPE Static Low Power
Mode
HPE Static High
Performance Mode
Minimum Processor Idle
Power Core C6 State
Enabled Enabled Disabled
Minimum Processor Idle
Power Core C1e State
Disabled Enabled Disabled
Maximum memory Bus
Frequency
Auto Auto Auto
Memory Interleaving
Channel Interleaving No Interleaving Channel Interleaving
PCI Express Generation
2.0 Support
Auto Force PCIe Generation
1
Auto
HyperTransport
Frequency
HT Full Performance
Mode
HT Power Saving Mode HT Full Performance
Mode
Dynamic Power Savings
Mode Response
Fast Slow Fast
DIMM Voltage
Preference
Optimized for
Performance
Optimized for Power Optimized for
Performance
Intelligent Provisioning Quick Configs settings and corresponding RBSU settings 41
To Next Page
Loading...
