• Static IPv6 Address 1—4– Enter up to four static IP addresses if they are not automatically assigned.
You must specify the prefix length for the addresses.
• Static Default Gateway—Enter a default IPv6 gateway address for cases in which no router
advertisement messages are present in the network.
• Static Route #1 (Destination/Gateway), Static Route #2 (Destination), Static Route #3—Enter static
IPv6 route destination prefix and gateway address pairs. You must specify the prefix length for the
destination. Link-local addresses are not allowed for the destination, but are allowed for the gateway.
To edit the settings on the IPv6 tab:
• In the iLO Configuration Utility window, click Network Settings. The General tab data appears.
• Click the IPv6 tab. The IPv6 tab data appears.
• Edit the setting(s) as necessary. Click Apply.
Network Settings–SNTP
• Use DHCPv4 Supplied Time Settings—Specifies whether iLO uses the DHCP server-supplied time.
• Use DHCPv6 Supplied Time Settings—Specifies whether iLO uses version 6 of the DHCP server-
supplied time.
• Propagate NTP Time to Host—Specifies whether ILO uses NTP time instead of the DHCP server-
supplied time.
• Primary Time Server—If DHCPv4 or DHCPv6 SNTP is not used, enter a time server address in the
Primary Time Server box.
• Secondary Time Server—If DHCPv4 or DHCPv6 SNTP is not used, enter a secondary time server
address in the Secondary Time Server box.
• Time Zone—A drop-down list of worldwide time zones.
To edit the settings on the SNTP tab:
• In the iLO Configuration Utility window, click Network Settings. The General tab data appears.
• Click the SNTP tab. The SNTP tab data appears.
• If you enabled DHCPv4 or DHCPv6 time settings, uncheck the appropriate check box.
• Edit the setting(s) as necessary. Click Apply.
Editing User Administration
Procedure
1. User Accounts—Displays available users.
Editing User Administration 51
To Next Page
Loading...
