1. Navigate to the Perform Maintenance page and select the Insight Remote Support option.
2. Click Unregister.
The following message appears:
This server is not registered.
Unregistering from Insight Remote Support central connect
Procedure
1. Log in to the Insight RS Console.
2. Do one of the following:
a. To stop monitoring a ProLiant server temporarily, select the server on the Devices > Device
Summary tab in the Insight RS Console, and then select ACTIONS > DISABLE SELECTED.
NOTE:
Unregistering the server directly from Intelligent Provisioning is the same as temporarily
disabling the server in the Insight RS Console.
b. To stop monitoring a ProLiant server permanently, delete the server from the Insight RS Console.
To delete the server, select it on the Device Summary tab, and then select ACTIONS > DELETE
SELECTED.
3. Navigate to the Perform Maintenance > HPE Insight Remote Support page in Intelligent
Provisioning.
4. Verify that the server is unregistered.
Editing the web proxy settings
Proxy settings must be maintained to enable a server to continue to send remote support data to HPE. If
the proxy settings change, use the following procedure to edit them:
Procedure
1. Navigate to the Perform Maintenance page and select HPE Insight Remote Support.
The HPE Insight Remote Support page opens.
2. On the HPE Insight Remote Support page, click Update Proxy.
3. In the Update Web Proxy Settings dialog box, update the following settings, as needed:
a. Web Proxy Server
b. Web Proxy Port
c. Web Proxy Username
d. Web Proxy Password
4. Click Update Proxy.
54 Editing the web proxy settings
To Next Page
Loading...
