Using a Deployment Settings package to configure a single server (overview)
IMPORTANT:
• Before using a deployment to install an OS, be sure that the drives and arrays are configured.
• Do not interrupt the configuration process.
• Deployment Settings are not compatible with an SD card (Available install methods, source
media types, and formats supported for each OS family) OS installation.
To use a Deployment Settings package to configure a single server:
Procedure
1. To use the deployment you just created on the server, click Deploy.
2. To use a previously created deployment, insert the USB key containing the deployment:
a. Save the deployment from the USB key to the local server.
b. In the Select a Deployment window, select the deployment from the list and click Deploy. If the
USB key and their stored deployments are not displayed, click Rescan.
3. As the deployment runs, validation settings are applied for the following elements:
• ROM Settings
• Array Settings
• System Options
• Firmware Update
• ERS Settings
The results of the validation settings are displayed, using the icons described in the following table.
Icon Result
Question mark Status unknown
Red box Error
Gray box Element not needed
Green check Element successfully applied
Information icon Click for additional information
Performing Deployment Settings package-level actions
Package-level actions manipulate the Deployment Settings package, not individual settings within a
deployment.
After making a selection in the initial page, the Select a Deployment window opens.
Using a Deployment Settings package to configure a single server (overview) 33
To Next Page
Loading...
