EasyManua.ls Logo

HP ProLiant Gen8 - Windows-Specific Issues; Linux-Specific Issues

HP ProLiant Gen8
65 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Windows-specific issues
Only flat files are supported over FTP. ISO files are not supported.
A standalone NIC card on the motherboard of the server takes the position of eth0 and eth1, pushing
the embedded NIC to eth2 and eth3.
After installing Windows, when viewing the Integrated Management Log (IML), the log may not
generate and the following error message may be displayed: No system management driver is
loaded. Suggested action: Use the Run as administrator option to launch the IML Viewer.
SNMP cannot be installed on HP-branded Windows Server 2008 Combo media using Intelligent
Provisioning. SNMP can be installed on HP-branded Windows Server 2008 R2 Combo media, which
is supported. Suggested action: Upgrade to Windows Server 2008 R2 or install the operating system
manually without Intelligent Provisioning.
No information is populated on the System Management Homepage after a Recommended installation
on Windows. This is expected behavior because by default only AMS is installed. Suggested action:
To populate the information in the SMH, install WBEM or SNMP agents.
Linux-specific issues
When using the Manual installation method SUSE Linux Enterprise Server 11 SP3 with an SD card,
the GNU GRUB screen appears, and the OS installation is not completed.
Suggested action: Perform the installation outside of Intelligent Provisioning by installing the DUD
from HPSC. A future upgrade will support the installation using Intelligent Provisioning.
The system displays an “Unsupported Hardware detected” message when you perform a
Recommended installation of Red Hat Enterprise Linux 6.3 on an SD card.
Suggested action: Click OK in the dialog box. The installation will proceed normally and concludes
successfully.
When using the Recommended installation method for one of the following:
Red Hat Enterprise Linux 5.8 or 5.9 with DVD source media
Red Hat Enterprise Linux 5.9 with DVD/FTP as source media on a Smart Array (SA) controller
Red Hat Enterprise Linux 5.X or 6.3 with an iSCSI media source
a Red Hat OS installation with FTP source mediayou might encounter one of the situations listed:
the installation hangs during reboot and a “The Red Hat Enterprise Linux Server CD was not found”
error appears.
the installation hangs and a “Could not allocate requested partitions” error appears.
the installation does not complete successfully, or
the installation completes successfully even if there are missing flat files for the OS installation.
Suggested action: To remedy any of the situations above, perform the installation outside of
Intelligent Provisioning by installing the DUD from HPSC.
60 Windows-specific issues

Table of Contents

Related product manuals