◦ 100BaseT, Full-duplex—Forces a 100 Mb connection using full duplex.
◦ 100BaseT, Half-duplex—Forces a 100 Mb connection using half duplex.
◦ 10Base T, Full-duplex—Forces a 10 Mb connection using full duplex
◦ 10Base T, Half-duplex—Forces a 10 Mb connection using half duplex.
To edit the settings on the General tab:
• In the iLO Configuration Utility window, click Network Settings. The General tab data appears.
• Edit the setting(s) as required. Click Apply.
Network Settings–IPv4
• Enable DHCPv4—Enables iLO to obtain its IP address (and many other settings) from a DHCP
server.
◦ Use DHCPv4 Supplied Gateway—Specifies whether iLO uses the DHCP server-supplied
gateway. If DHCP is not used, enter a gateway address in the Gateway IPv4 Address box.
◦ Use DHCPv4 Supplied Static Routes—Specifies whether iLO uses the DHCP server-supplied
static routes. If not, enter the static route destination, mask, and gateway addresses in the Static
Route #1, Static Route #2, and Static Route #3 boxes.
◦ Use DHCPv4 Supplied Domain Name—Specifies whether iLO uses the DHCP server-supplied
domain name. If DHCP is not used, enter a domain name in the Domain Name box on the Shared
Network Port page.
◦ Use DHCPv4 Supplied DNS Servers—Specifies whether iLO uses the DHCP server-supplied
DNS server list. If not, enter the DNS server addresses in the Primary DNS Server, Secondary
DNS Server, and Tertiary DNS Server boxes.
◦ Use DHCPv4 Supplied Time Settings—Specifies whether iLO uses the DHCPv4 server-supplied
time.
◦ Use DHCPv4 Supplied WNS Servers—Specifies whether iLO uses the DHCP server-supplied
WINS server list. If not, enter the WINS server addresses in the Primary WINS Server and
Secondary WINS Server boxes.
• IPv4 Address—The iLO IP address. If DHCP is used, the iLO IP address is supplied automatically. If
DHCP is not used, enter a static IP address.
• Subnet Mask—The subnet mask of the iLO IP network. If DHCP is used, the subnet mask is supplied
automatically. If DHCP is not used, enter a subnet mask for the network.
• Gateway IPv4 Address—The iLO gateway IP address. If DHCP is used, the iLO gateway IP address
is supplied automatically. If DHCP is not used, enter the iLO gateway IP address.
• Static Route #1, Static Route #2, and Static Route #3—The iLO static route destination, mask, and
gateway addresses. If Use DHCPv4 Supplied Static Routes is used, these values are supplied
automatically. If not, enter the static route values.
• Primary DNS Server—Enter the IPv4 address for the primary DNS service.
• Secondary DNS Server—Enter the IPv4 address for the secondary DNS service.
• Tertiary DNS Server—Enter the IPv4 address for the tertiary DNS service.
Using Intelligent Provisioning 49
To Next Page
Loading...
