Power up the server
Procedure
To power up the server, press the Power On/Standby button.
Remove the server from the chassis
CAUTION:
Before removing the server, verify that the server backup LED is not flashing.
Procedure
1. Power down the server on page 21.
CAUTION:
To avoid damage to the server, always support the bottom of the server when removing it from
the chassis.
2. Remove the server from the chassis.
NOTE: To avoid damage to the device, do not use the removal handle to carry it.
3. Place the server on a flat, level work surface.
Install a server
CAUTION:
To prevent improper cooling and thermal damage, do not operate the chassis unless all bays are
populated with a component or a blank.
22 Power up the server
To Next Page
Loading...
