To Next Page

To Previous Page

Page 14

792519-001 Edition 1

ENGLISH

3. Installation

3.2 Battery module connection

This operation must be performed when the UPS is switched o and unplugged from the AC source. In addition, do not

disconnect the connector while the unit is operating from the AC source or in reserve mode.

Note: Before starting the UPS, connect the internal battery. A small amount of arcing may occur when connecting the

batteries.This is normal and does not damage the UPS or present any safety concern.

Installing the new battery module

Perform the removal instructions in reverse order.

● To ensure safety and high performance, only use batteries supplied by HP.

● Take care to firmly press together the two parts of the connector during remounting.

Connect the battery module.

Never pull on the wires.

Slide the left-hand side of the bezel to

the right. Ensure that the push button

locks.

Attach the center panel.

Questions and Answers:

Need help?

Do you have a question about the HP R/T3000 G4 ERM and is the answer not in the manual?

HP R/T3000 G4 ERM Specifications

General