To Next Page

To Previous Page

Touch control board

Description Spare part number

Touch control board (does not include cable) L38692-001

Before removing the touch control board, follow these steps:

1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn

the computer on, and then shut it down through the operating system.

2. Disconnect all external devices connected to the computer.

3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and then

unplugging the AC adapter from the computer.

4. Remove the display panel (see Display panel on page 25).

Remove the touch control board:

1. Release the ZIF connectors (1) to which the touch control board cables are connected, and then disconnect

the touch control board cables (2) from the touch control board.

2. If it is necessary to replace the touch control board cable, release the ZIF connector (3) to which the touch

control board cable is connected, and then disconnect the touch control board cable (4) from the touch

control board.

NOTE: The touch control board cable is available using spare part number L38673-001.

Reverse this procedure to install the touch control board and cable.

30 Chapter 5 Removal and replacement procedures

Questions and Answers:

Need help?

Do you have a question about the HP Spectre Folio and is the answer not in the manual?

HP Spectre Folio Specifications

General