StatusDescriptionItem
Flashing blue:
• 1 Hz/cycle per sec = Remote
management or firmware upgrade
in progress
• 4 Hz/cycle per sec = iLO manual
reboot sequence initiated
• 8 Hz/cycle per sec = iLO manual
reboot sequence in progress
Off = Deactivated
1
When these four LEDs flash simultaneously, a power fault has occurred.
2
If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health
status.
3
This LED behavior applies to all front drives, and to the rear drives connected to the front drive cage 2 backplane.
4
This LED behavior depends on the iLO 08-HD Max sensor reading.
5
Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has
occurred, or the front I/O cable is disconnected.
Figure 14 StoreEasy 1650 Expanded Storage rear panel LEDs
StatusDescriptionItem
Solid green = Link to networkDedicated iLO activity LED1
Flashing green = Network active
Off = No network activity
Green = Network linkDedicated iLO link LED2
Off = No network link
Solid green = Link to networkNIC activity LED3
Flashing green = Network active
Off = No network activity
Green = Network linkNIC link LED4
Off = No network link
Solid blue = ActivatedUID LED5
Flashing blue:
• 1 Hz/cycle per sec = Remote
management or firmware upgrade
in progress
• 4 Hz/cycle per sec = iLO manual
reboot sequence initiated
• 8 Hz/cycle per sec = iLO manual
reboot sequence in progress
Hardware components 17
To Next Page
Loading...
