To Next Page

To Previous Page

Removal andreplacement procedures

preliminary requirements

Use this information to properly prepare to disassemble and reassemble the computer.

Tools required

You need the following tools to complete the removal and replacement procedures:

● Tweezers

● Nonconductive, nonmarking pry tool

● Magnetic Phillips P1 screwdriver

Service considerations

The following sections include some of the considerations that you must keep in mind during disassembly and

assembly procedures.

NOTE: As you remove each subassembly from the computer, place the subassembly (and all accompanying

screws) away from the work area to prevent damage.

Plastic parts

Using excessive force during disassembly and reassembly can damage plastic parts.

Cables and connectors

Handle cables with extreme care to avoid damage.

IMPORTANT: When servicing the computer, be sure that cables are placed in their proper locations during

the reassembly process. Improper cable placement can damage the computer.

Apply only the tension required to unseat or seat the cables during removal and insertion. Handle cables by

the connector whenever possible. In all cases, avoid bending, twisting, or tearing cables. Be sure that cables

are routed so that they cannot be caught or snagged as you remove or replace parts. Handle ex cables with

extreme care; these cables tear easily.

Drive handling

Note the following guidelines when handling drives.

IMPORTANT: Drives are fragile components. Handle them with care. To prevent damage to the computer,

damage to a drive, or loss of information, observe these precautions:

Before removing or inserting a hard drive, shut down the computer. If you are unsure whether the computer

is o or in Hibernation, turn the computer on, and then shut it down through the operating system.

Chapter 4Removal andreplacement procedures preliminary requirements

HP Victus User Manual

Questions and Answers: