6. Remove the grounding tape from the right screw (5).
7. Remove the three Phillips M2.0 × 2.5 screws (1) that secure the touchpad to the computer.
8. Remove the touchpad (2).
To install the touchpad, reverse this procedure.
Plastic rear vent and
n
To remove the plastic rear vent and n, use this procedure and illustration.
Table 6-12
Plastic rear vent and n descriptions and part numbers
Description Spare part number
Dummy n N13308-001
Plastic rear vent N13307-001
Before removing the plastic rear vent and n, follow these steps:
56
Chapter 6Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
