Using Computer Setup (F10) Utility to reset CMOS
1. Access Computer Setup (F10) Utility menu.
2. When the computer setup message appears in the lower-right corner of the screen, press F10, and
then press Enter to bypass the title screen, if necessary.
If you do not press F10 while the message is displayed, the computer must be rebooted to access
this utility.
3. From Computer Setup (F10) Utility menu, select File > Default Setup.
This restores the settings that include boot sequence order and other factory settings. However, it
does not force hardware rediscovery.
4. Choose Restore Factory Settings as Default, and then press F10 to accept.
5. Select File > Apply Defaults and Exit, and then press Enter to accept.
6. Reset the computer passwords and configuration information, such as the system date and time.
NOTE: This step does not clear the passwords.
96 Chapter 5 Configuring password security and resetting CMOS
To Next Page
Loading...
