3. Spread the retaining tabs (1) on each side of the memory module slot to release the memory module. (The
memory module tilts up.)
4. Remove the memory module (2) by pulling it away from the slot at an angle.
NOTE: Memory modules are designed with notches to prevent incorrect insertion.
Reverse this procedure to install a memory module.
Solid-state drive
Description Spare part number
1-TB, 2280.M2, PCIe-3×4, NVMe, DS solid-state drive L11069-001
1-TB, 2280.M2, PCIe-3×4, SS, HP Z Turbo Drive solid-state drive with TLC L12500-001
512-GB, 2280.M2, PCIe-3×4, NVMe, HP Z Turbo Drive solid-state drive L11071-001
512-GB, 2280, PCIe-3×4, SED, HP Z Turbo Drive solid-state drive with Opal2 and TLC L11072-001
512-GB, M2, SATA-3, FIPS solid-state drive with TLC L11067-001
256-GB, 2280.M2, PCIe-3×4, NVMe, SS, HP Z Turbo Drive solid-state drive with TLC L11070-001
256-GB, PCIe, NVMe, solid-state drive, HP Z Turbo Drive with MLC L11073-001
128-GB, M.2, SATA-3 solid-state drive L11068-001
Before removing the solid-state drive, follow these steps:
1. Shut down the tablet. If you are unsure whether the tablet is o or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the tablet.
Component replacement procedures 55
To Next Page
Loading...
Need help?
General
