Figure 21: Removing an HPE 3PAR StoreServ 7000 Storage Bezel
Installation:
8. Remove the slot-filler Blanks from where you will be installing the Drive pairs.
9. Install the Drive.
a. On the Drive, press the release button to open the handle.
b. With the latch handle of the Drive fully extended, align and slide the Drive into the bay until the
handle begins to engage (1).
c. To seat the Drive into the Drive bay, close the handle (2).
Figure 22: Installing an HPE 3PAR StoreServ 7000 Storage SFF Drive
Upgrade of the storage system 41
To Next Page
Loading...
