cli% showpd -s 3
Id CagePos Type -State-- -Detailed_State- --SedState
3 0:3:0 FC degraded old_firmware fips_capable
------------------------------------------------------
1 total
cli% showpd -i 3
cli% showfirmwaredb
pd Example 5
Component --Identifier-- -------Detailed Description----------
PD -- Sparing Algorithm is not set
pd Suggested Action 5
Check the system’s Sparing Algorithm value using the CLI command showsys -param . The value is
normally set during the initial installation (OOTB). If it must be set later, use the command setsys
SparingAlgorithm ; valid values are Default, Minimal, Maximal, and Custom. After setting the
parameter, use the admithw command to programmatically create and distribute the spare chunklets.
cli%
showsys -param
System parameters from configured settings
----Parameter----- --Value--
RawSpaceAlertFC : 0
RawSpaceAlertNL : 0
RawSpaceAlertSSD : 0
RemoteSyslog : 0
RemoteSyslogHost : 0.0.0.0
SparingAlgorithm : Unknown
pd Example 6
Component --Identifier-- -------Detailed Description----------
PD Disk:32 ST3400755FC PD for cage type DCS2 in cage position 2:0:0 is missing from the firmware
database
pd Suggested Action 6
Check the release notes for mandatory updates and patches to the HPE 3PAR OS version that is
installed and install as needed to support this PD in this Drive Enclosure (cage).
pdch
• Displays chunklets state issues
• Checks LD connection paths, remote chunklets, and remote disks
pdch 85
To Next Page
Loading...
