HPE 3PAR StoreServ 7000 Storage

FC onboard ports numbering
Port Node:Slot:Port (N:S:P)
FC-1 N:0:1
FC-2 N:0:2
Controller Node Enclosure rear view
Figure 50: HPE 3PAR StoreServ 7000 Storage Controller Node Enclosure rear view
HPE 3PAR StoreServ 7000 Storage Controller Node Enclosure rear view
Item Description
1 Power connection 0 This power connection requires a power cable to be attached between the
power supply and an independent electrical source. This electrical source
must support the entire power load of the enclosure and have its own
circuit breaker.
2 Power Cooling Module 0 The Power Cooling Module (PCM) is an integrated power supply and
cooling fan and also contains a replaceable battery. The PCM battery is
shipped fully charged, but the batteries might lose some charge and show
a degraded status immediately when power is applied. One PCM can
supply enough power for the Controller Node Enclosure. Connect each
PCM to draw power from different mains to allow for continued operation if
one main fails.
3 Controller Node 0 The Controller Node caches and manages data from the storage system
and provides hosts with a coherent, virtualized view of the storage system.
4 Controller Node 1 The Controller Node caches and manages data from the storage system
and provides hosts with a coherent, virtualized view of the storage system.
5 Power Cooling Module 1 The Power Cooling Module (PCM) is an integrated power supply and
cooling fan and also contains a replaceable battery. The PCM battery is
shipped fully charged, but the batteries might lose some charge and show
a degraded status immediately when power is applied. One PCM can
supply enough power for the Controller Node Enclosure. Connect each
PCM to draw power from different mains to allow for continued operation if
one main fails.
Table Continued
116 Controller Node Enclosure rear view