cli% showport
N:S:P Mode State ----Node_WWN---- -Port_WWN/HW_Addr- Type Protocol Label Partner
FailoverState
...
0:0:1 target ready 2FF70002AC00006E 20110002AC00006E host FC - 1:0:1
none
0:0:2 target offline 2FF70002AC00006E 20120002AC00006E free FC - 1:0:2
none
...
port Example 4
Component ------------Summary Description------------ Qty
Port Ports with mismatched mode and type 1
Component -Identifier- ------Detailed Description-------
Port port:2:0:3 Mismatched mode and type
port Suggested Action 4
This output indicates that the port's mode, such as an initiator or target, is not correct for the connection
type, such as drive, host, ISCSI, FCoE, or RCFC. Useful HPE 3PAR CLI commands are showport,
showport -c, showport -par, showport -rcfc, showcage, etc.
cli%
showport
Component -Identifier- ------Detailed Description-------
Port port:0:1:1 Mismatched mode and type
cli% showport
N:S:P Mode State ----Node_WWN---- -Port_WWN/HW_Addr- Type
0:1:1 initiator ready 2FF70002AC000190 20110002AC000190 rcfc
0:1:2 initiator loss_sync 2FF70002AC000190 20120002AC000190 free
0:1:3 initiator loss_sync 2FF70002AC000190 20130002AC000190 free
0:1:4 initiator loss_sync 2FF70002AC000190 20140002AC000190 free
qos
• Displays Quality of Service (QOS) issues
• Checks for Quality of Service rejects over the previous 24 hours
Format of Possible qos Exception Messages
QOS <vvsetname> "VVSet has logged <count> rejects in 24 hours"
qos Example
90 qos
To Next Page
Loading...
