Date -- "Date is not the same on all nodes"
date Example
Component -Identifier- -----------Detailed Description-----------
Date -- Date is not the same on all nodes
date Suggested Action
The time on the Controller Nodes should stay synchronized whether there is an NTP server or not. Use
showdate to see if a Controller Node is out of sync. Use shownet and shownet -d to see the network
and NTP information. NTP will not adjust the time for significant time differences, use the setdate CLI
command to set the time, date and time zone on all Controller Nodes.
cli% showdate
Node Date
0 2010-09-08 10:56:41 PDT (America/Los_Angeles)
1 2010-09-08 10:56:39 PDT (America/Los_Angeles)
cli% shownetshowdatesetdate -tz America/Denversetdate 05211532showdate
file
Displays file system conditions that are not optimal:
• Checks that required system volumes are mounted
• Checks for process, kernel and HBA cores on Controller Node disk drives
• Checks for Controller Node file systems that are too full
• Checks for behavior altering files on the Controller Node disk drives
• Checks if an online upgrade is in progress
Many issues reported by the file component will require you to contact the Hewlett Packard Enterprise
Support Center to request support your system.
Format of Possible file Exception Messages
File <nodeID> "Filesystem <filesystem> mounted on "<mounted on>" is over <count>%
full"
File <nodeID> "Behavior altering file "<filename>" exists, created on <date&time>"
File <nodeID> "Dump or HBA core files found"
File <nodeID> "sr_mnt is full"
File -- "sr_mnt not mounted"
File -- "Admin Volume is not mounted"
File -- "An online upgrade is in progress"
72 file
To Next Page
Loading...
