EasyManua.ls Logo

HPE 3PAR StoreServ 7000 Storage

HPE 3PAR StoreServ 7000 Storage
147 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PD disk:<pdid> "Degraded States: <showpd -s -degraded>"
PD disk:<pdid> "Failed States: <showpd -s -failed">
PD -- "Sparing algorithm is not set"
PD disk:<pdid> "Disk is experiencing a high level of I/O per second: <iops>"
PD File: <filename> "Folder not found on all Nodes in <folder>"
PD File: <filename> "Folder not found on some Nodes in <folder>"
PD File: <filename> "File not found on all Nodes in <folder>"
PD File: <filename> "File not found on some Nodes in <folder>"
PD Disk:<pdID> "<pdmodel> PD for cage type <cagetype> in cage position <pos> is missing from firmware database"
PD Cage:<cageID> "There must be at least 1 PD with primary path to Node:<nodeID>"
PD Cage:<cageID> "PDs <class/rpm/cap> unbalanced. Primary path: <p_count> on Node:<nodeID>, <c_count> on
Node:<nodeID>"
PD Nodes:<nodelist> "Only <count> <class/rpm/cap> PDs are attached to these nodes; the minimum is <MINDISKCNT>"
PD pd:<pdID> "PD SAS speed is <speed> instead of <speed> on both ports"
PD pd:<pdID> "PD SAS speed is <speed> instead of <speed> from port <0|1>"
PD disk:<pdWWN> "Unadmitted PD in cage position <CagePos> Type <devType>"
PD cage:<cageID>,mag:<magID> "Magazine has a failed servicemag operation"
PD cage:<cageID>,mag:<magID> "Magazine is being serviced"
PD cage:<cageID>,mag:<magID> "Magazine has an active servicemag operation in progress"
pd Example 1
Component -------------------Summary Description------------------- Qty
PD PDs that are degraded or failed 40
Component -Identifier- ---------------Detailed Description-----------------
PD disk:48 Detailed State:
missing_B_port,loop_failure
PD disk:49 Detailed State:
missing_B_port,loop_failure
...
PD disk:107 Detailed State: failed,notready,missing_A_port
pd Suggested Action 1
Both degraded and failed Drives show up in this report. When an FC path to a Drive Enclosure (cage) is
not working, all Drives in the cage have a state of Degraded due to the non-redundant condition. Use
commands such as showpd, showpd -s, showcage, showcage -d.
cli%
showpd -degraded -failed
----Size(MB)---- ----Ports----
Id CagePos Type Speed(K) State Total Free A B
48 3:0:0 FC 10 degraded 139520 115200 2:0:2* -----
49 3:1:0 FC 10 degraded 139520 121344 2:0:2* -----
107 4:9:3 FC 15 failed 428800 0 ----- 3:0:1*
cli% showpd -s -degraded -failed
cli% showcage -d cage3
pd Example 2
82 Troubleshooting

Table of Contents

Related product manuals