HPE FlexNetwork 5510 HI Series Openflow Configuration Guide

10
Step Command Remarks
2. Enter OpenFlow instance view.
openflow instance
instance-id N/A
3. Set the controller mode.
controller mode
{
multiple
|
single
}
By default, the controller mode
is
multiple
.
Setting the maximum number of flow entries for an
extensibility flow table
You can set the maximum number of flow entries that an extensibility flow table supports. When the
maximum number is reached, the OpenFlow instance does not accept new flow entries for that table
and sends a deployment failure notification to the controller.
To set the maximum number of flow entries that an extensibility flow table supports:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter OpenFlow instance
view.
openflow instance
instance-id N/A
3. Set the maximum number of
extensibility flow entries.
flow-entry max-limit
limit-value
By default, an OpenFlow
extensibility flow table supports up
to 65535 flow entries.
Configuring inband management VLANs
Inband management VLANs are used to establish connections between an OpenFlow instance and
controllers.
When the inband management VLANs are configured, the data packets within the inband
management VLANs are not forwarded through OpenFlow. The ports that are assigned to only
inband management VLANs are not OpenFlow ports. Before configuring inband management
VLANs, you must plan the network.
To configure inband management VLANs:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter OpenFlow
instance view.
openflow instance
instance-id N/A
3. Configure inband
management
VLANs.
in-band management vlan
vlan-list
By default, no inband management
VLAN is configured.
The inband management VLANs of an
OpenFlow instance must be within the
list of the VLANs that are associated with
the OpenFlow instance.

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English